Selection and use of edible fungi machinery

With the development of edible fungi production, machinery for the production of edible fungi has also been promoted and used. The following describes the selection and use of several edible fungi machinery for reference.

1. Wood chip crusher. Usage: (1) Open the upper cover to check whether the hammer is tight, if the bolt is loose, then add enough butter and start the test. (2) Start feeding after the machine is running normally. If abnormal noise occurs, stop the inspection immediately to avoid damage to the machine. (3) When the hammer wear causes a significant drop in productivity, it should be removed and replaced, or replaced with a new hammer. (4) Feeding must be uniform, do not overload.

2. Culture material bagging machine. This machine is commonly used in automatic mushroom bagging machine and semi-automatic mushroom, oyster mushroom and enoki mushroom three-purpose bagging machine, with 2.2 kW motor, suitable for blowing film bags with diameter of 150-240 mm, productivity is per 800-1000 bags per hour. Usage: (1) Check whether the screws of each part are tight, then turn on the power, and then feed the standby after normal operation. (2) When bagging, one hand gently support the outlet of the sleeve, hold the end of the plastic bag with one hand, and let the plastic bag slowly withdraw while feeding. (3) To use different bags, you need to change the corresponding auger and auger. (4) When the hopper overhead occurs occasionally, the material in the bucket should be dialed in time. Do not put your hand in to avoid rolling injury. (5) If the machine does not discharge, stop it to check if the auger is worn or deformed.

3. Sterilize the atmospheric pressure cooker. Can be loaded with 180-250 edible fungus bags. Fuel coal, firewood can be. Usage: (1) The safety valve pressure should be adjusted to about 147.12 kPa for automatic exhaust. (2) Add enough water in the pot before ignition. The bacteria bag should be placed in the pot to be stable. The outer bag should be kept at a distance of 110 mm from the lid. (3) Remove the sludge impurities in the rubber ring and the corresponding cover before the pot is closed to prevent air leakage. (4) In the middle of sterilization, it is not possible to stop the fire and cool down, so as to avoid the cotton plug being stained with water. (5) After sterilization, the venting valve should be opened to discharge the gas in the pot. When the pressure in the pot is 47.04-98.08 kPa, close the bleed valve. Open the water valve, drain the water in the pot, and then drain the gas in the pot before opening the lid to take the bag.

4, mushroom dryer. The machine can dry about 30 kilograms of mushrooms in 8 hours. The temperature is controlled during use; the wetness fan is fully open at the beginning of drying, half-open in the middle, and fully closed in the later stage. After drying, first extinguish the fire, then open the drying room to take the product. The soot in the heat exchanger piping should be removed first when continuing to use.

Small Capacity Solvent Recovery Machine

Small capacity Solvent Recovery Machine

Characteristic

●Explosion-proof electric equipment: in compliance with Chinese safety standards (CNEX) and European standards (ATEX), worry-free and safe for use;

●Self-developed high-end standardized production, stable and durable quality assured, has good performance;

●High quality durable stainless steel tank, prevent chemical corrosion; two-tier structure, indirect heating, reinforcement barrelhead design, precise temperature control, explosion-proof, anti-leakage;

●Heating Method: heat medium (heat transfer oils) indirect heating;

●Digital heating temperature controller: advanced numerical performance, safety intuitive, accurate and convenient heating temperature control;

●Multiple operational safety protection functions: pre-set temperature shutdown function; timer shut off function; ultra-high temperature protection features; high-voltage protection function; power failure protection function.

●A 24-hour automatic cycle operation functions: a single cycle or continuous cycle operation, a 24-hour automatic cycle of operation.

●Vacuum decompression recovery features: built-in vacuum (pump) devices, heating, condensation, vacuum, storage features and variety of functions in one machine; heating temperature is low, saving heating electricity; sealed recycling, reduces evaporation, prevents leakage; right volatility and easy to decompose, toxic or high boiling point solvent recovery with excellent effect.

●Automatic feeding and automatic cleaning residue functions: automatic or manual control feeding, without opening the cover feeding; cleaning of residue without need to open the lid, after recovery emptying is done by air pressure, high efficiency, low solvent evaporation, saves energy and cost of labor.

Small Capacity Solvent Recovery Machine,Small Butanone Recovery Equipment,Small-scale Solvent Recycling Machine,Thinner Recycler Machine

SHENZHEN KUANBAO ENVIRONMENTAL EQUIPMENT CO., LTD , https://www.calstarkb.com