Agricultural machinery troubles can be used for tips
Cleverly repair clutch pedal. When the cross-stitch of the clutch pedal is flattened, the foot slides easily when the pedal is pressed, and it is easy to slip in rainy days. If a suitable length of rebar is welded on both the upper and the lower side of the pedal, the rebar plane will be 5 mm above the pedal plane so that it will not slip when used.
Clever row of oil pump air. For the S195 diesel engine, if the pump air is not drained, there will be no oil pumping failure. The trick is to use a medical waste needle to fill up the oil and pump it to the pump inlet. And turn the oil pump so that the outlet discharges oil.
Breaking paper mats cleverly patched. Connect the breaks, apply a little butter on both sides of the paper pad, and cut two pieces of white paper of the same size as the paper pad, stick them on both sides of the paper pad, and put them on the machine. Tighten the nuts to eliminate the leakage.
Qiaozhi tire leaks slowly. Take two tablespoons of talcum powder, pull off the valve core, put away the air inside the tube, use a piece of hard paper to make a funnel, and pour talc into the inner tube. Then fill the valve core with sufficient gas, talcum powder in the tire was diffusely attached to the inner wall, you can block the small air leakage.
Cleverly decompression gear outer elastic retaining ring. The external elastic ring of the reduction gear in the gearbox of Dongfeng-12 type tractor is very difficult to disassemble. A fine wire can be used to pass through the small hole in the retaining ring and screw it tightly. The other end is screwed up with a screwdriver and tightly pulled. Then the drive wheel is rotated back and forth several times to remove the retaining ring.
In addition to the dirt inside the fine filter. The dirt and dirt in the rotor oil filter cannot be easily removed. If a layer of paper is applied to the inner wall of the rotor with butter, and the soil is attached to the paper, the paper can be removed and the soil can be completely removed.
Check the parts cracks. Put the parts into the kerosene, remove them over a period of time, dry the surface and sprinkle with a layer of white powder, then tap the parts with a small hammer. If there is a crack, the kerosene that has been immersed in the cracks will Cracks ooze out and cracks appear on the white powder.
Demolition of the old cylinder liner. Use the old old piston pin to install the old piston of the machine, install one or two old piston rings on the old piston, and use a small steel bar with a diameter of 6.50 mm to hook the old piston pin and insert the piston into the cylinder. When the piston ring exceeds the lower edge of the cylinder liner, it will automatically pop open and hold the cylinder liner. At this time, the small steel bar is wrapped around the wooden stick, and then the cylinder sleeve is removed by lifting the wooden stick.
HEBEI PINGLE FLOUR MACHINERY GROUP CO., LTD , https://www.plrollermill.com